Pliant Technologies is the leading provider of critical communication solutions

×

Notice:

This website uses cookies and other technologies so we can remember you and understand how you and other visitors use our site. By closing this banner, scrolling this page, clicking a link or continuing to browse otherwise, you agree to the use of cookies. Learn More.

Tempest BaseStation Firmware

Tempest BaseStation Firmware

Please follow the steps below for upgrading the Tempest BaseStation Firmware 3.20.00:

  1. Download the firmware for either the 4-channel or 2-channel BaseStation
 
  2. Download the PIC file for either the 4-channel or 2-channel BaseStation
 
  3. Prepare the BaseStation for updating
 
  • With the BaseStation power OFF, press and hold the "MIC KILL" button and power the BaseStation ON
  • The BaseStation LCD should indicate that it is ready for a "New Image"
  • Connect the USB cable from your PC to the USB B connector on the front of the BaseStation
  4. Locate the target device
 
  • Click the "Locate Device" button in Code Updater
  • The banner of Code Updater should indicate what target you are attempting to program - In this case it should say "base"
  5. Point Code Loader to the Firmware (.hex) file
 
  • Click the "Browse" button and locate the Firmware (.hex) file that you located in step 1 above
  • You may only upgrade one BaseStation Firmware file at a time (DSP or PIC)
  6. Upgrade the BaseStation
 
  • Click the "Upgrade" button
  • The target will self program and boot
Note: It may be necessary to pair BeltStations to BaseStations again after upgrading the Firmware.