Pliant Technologies is the leading provider of critical communication solutions

×

Notice:

This website uses cookies and other technologies so we can remember you and understand how you and other visitors use our site. By closing this banner, scrolling this page, clicking a link or continuing to browse otherwise, you agree to the use of cookies. Learn More.

Tempest BeltStation Firmware

Tempest BeltStation Firmware

Please follow the steps below for upgrading the Tempest BeltStation Firmware:

 

 1. Download the firmware for either the 4-channel or 2-channel system

  2. Prepare the BeltStation for updating
 
  • With the BeltStation power OFF, press and hold the "CALL" button and power the BeltStation ON
  • The BeltStation LCD should indicate that it is ready for a "New Image"
  • Connect the USB cable from your PC to the Mini USB connector on the side of the BeltStation located under the rubber flap
  3. Locate the target device
 
  • Click the "Locate Device" button in Code Updater
  • The banner of Code Updater should indicate what target you are attempting to program - In this case it should say "belt"
  4. Point Code Loader to the Firmware (.hex) file
 
  • Click the "Browse" button and locate the Firmware (.hex) file that you located in step 1 above
  5. Upgrade the BeltStation
 
  • Click the "Upgrade" button
  • The target will self program and boot

Note: It may be necessary to pair BeltStations to BaseStations again after upgrading the Firmware.